Pre-Harvest Winery Chiller Checklist

The best time to find a problem with a winery cooling system is before harvest, while the Tanks are empty. This is the list we work through on a pre-harvest visit. Most of it is about catching worn parts and weak glycol before the load arrives.

Serving Sonoma and Napa counties

Lewis Mechanical service truck at a mechanical installation

Chiller

Clean and inspect the Condenser Coils and Fans. Check refrigerant pressures, superheat and subcooling for leaks or a low charge. Check Compressors, Contactors and electrical connections. Test the safety switches and alarms.

Glycol loop

Test glycol concentration and freeze point and adjust the mix for the coldest setpoint you will run. Check the level, purge air, clean Strainers and look for leaks at Valves, unions and Tank jackets.

Pumps

Check Pump Seals, bearings and Motor current, and confirm flow. A Pump that is noisy or leaking now will usually fail during crush.

Tank Controls

Confirm every Tank Valve opens and closes, sensors read correctly and setpoints are where the winemaker wants them. Check remote access and alarm notifications if you have them.

Heating for warm Tanks

If you warm Tanks with a Boiler or glycol heater, check combustion, safety Controls, Pumps and the hot side of the loop as well.

Backup plan

Know what you will do if a Chiller fails in the middle of crush. Rental Glycol Chillers can carry the load, but they book up at harvest, so plan early.

Updated November 16, 2026

Request a Service or Quote

We’ll follow up to confirm the details and schedule a visit.

Equipment down or production affected?

After-hours service is for Maintenance & Service Agreement customers. Online requests are reviewed during office hours.

(707) 544-1277

Prefer to write a message or attach a file? Use our contact form.